Stone Bar Handles

A long bar of agate, jasper, amethyst or rose quartz on brass fittings, edged in electroformed metal. Taken in the whole hand rather than pinched.

Each handle is one long slice of stone, about 6 inches end to end and an inch wide, drilled for two screws and mounted upright on brass fittings. A thin electroformed metal edge runs along the stone, in gold, silver or rose gold. Stones are black, white, blue, green, red and sage green agate, kambaba jasper, amethyst and rose quartz. The two screws sit 4 inches apart, so measure between the centers of your old holes before you order.

The two cast brass handles are in Brass Figure Handles. Single-hole knobs are in Cabinet Knobs.

Frequently asked questions

How far apart are the screws?

4 inches (10 cm), center to center. Measure your old holes before you order.

Are the four handles the same?

No. Each is cut from a different part of the stone, so the color and banding change from one to the next.

Is a stone handle strong enough for daily use?

Yes. The load goes through the two screws and the brass fittings, not through the stone.